ERSA EA 55i solder fume extraction -

The filter unit ERSA Easy Arm Extraction EA 55 i is a compact and powerful system to efficiently clean soldering process air at the workbench. Utilized with either the i-CON1 C or i-CON2 C soldering stations, connected with an interface cable, this filter system opens up a completely new dimension of intelligent solder fume extraction.

The extraction unit can be operated in the continuous mode, or, with an i-CON connected, it is only working whilst the attached soldering station is in operation, stopping as soon as the soldering station goes into standby mode. Filter usage times are increased; energy costs and operational noise level are significantly reduced.

The EA 55 i can be installed variably and easily, and the flexible extraction arm bends easily into the desired position. A very low operation noise level and its robust metallic case allow running the system in basically all industrial surroundings from testing floor and laboratories to electronic production.

The solder fume filtration occurs in three stages: First a pre-filter captures the large particles. Then the HEPA particulate filter removes all the remaining hazardous particles. Finally the activated carbon gas filter adsorbs any harmful gas molecules. The powerful blower guarantees an adequate airflow throughout the filter life. An optical alarm indicates necessary filter changes.

In this way, the EA 55 i not only sucks in harmful gases efficiently, but also cleans the dirty process air at the same time. Consequently the new ERSA solder fume extraction is not only a cost-effective but also an environmentally friendly solution saving resources and thus offering benefits for everyone.